Using command line, is it possible to change the output file

Get help with installation and running here.

Moderators: DataMystic Support, Moderators, DataMystic Support, Moderators, DataMystic Support, Moderators

Post Reply
Brett C
Posts: 1
Joined: Thu Jan 18, 2007 5:01 am

Using command line, is it possible to change the output file

Post by Brett C »

Hi, we're trying to create a batch file that will run for hundreds of projects. We would like to keep information about these projects separate so I was just wondering if there's some way to change the output file using command lines? They all use the same filter so we can't do it in the regular interface.

Thanks for your time.

- Brett
User avatar
DataMystic Support
Site Admin
Posts: 2227
Joined: Mon Jun 30, 2003 12:32 pm
Location: Melbourne, Australia
Contact:

Post by DataMystic Support »

Yes, use /MERGETOFILE=
Regards,

Simon Carter, https://www.DataMystic.com
https://www.JadeDiabetes.com - Insulin dose calculator for Type 1 diabetes
https://www.DownloadPipe.com - 250,000 free software downloads
Post Reply