There is probably a very obvious answer to this question, but I cannot for the life of me find the answer anywhere. I want to set up a serious of restric and convert filters and sub-filters which I am able to do. However, at each stage I want to add an 'output filter' to each of the sub-filters. How do you add a subfilter to a sub-filter??
Thanks
Luke
Adding an output filter (to a subfilter)
Moderators: DataMystic Support, Moderators, DataMystic Support, Moderators, DataMystic Support, Moderators
- DataMystic Support
- Site Admin
- Posts: 2229
- Joined: Mon Jun 30, 2003 12:32 pm
- Location: Melbourne, Australia
- Contact:
Sounds like you need a Filters\Special\Secondary output filter, which is usually followed by a Filters\Remove\All filter to prevent the text re-entering the filter stream.
To add a subfilter, just drag and drop one filter inside the other.
To add a subfilter, just drag and drop one filter inside the other.
Regards,
Simon Carter, https://www.DataMystic.com
https://www.JadeDiabetes.com - Insulin dose calculator for Type 1 diabetes
https://www.DownloadPipe.com - 250,000 free software downloads
Simon Carter, https://www.DataMystic.com
https://www.JadeDiabetes.com - Insulin dose calculator for Type 1 diabetes
https://www.DownloadPipe.com - 250,000 free software downloads