Page 1 of 1
Go (Real) output different than the Trail Run output???
Posted: Wed Nov 02, 2005 3:18 am
by cities4rent
I've got a routine that works when I run the 'Trial Run'. But when I then run the 'Go (Real)', I get different results. Even when I just run it for one datafile...with the datafile and the Trial Input being exactly the same.
Any suggestions???
Davidj.
Textpipe 6.2.5
Posted: Wed Nov 02, 2005 3:56 am
by Guest
While I'm still not sure why the Trial Run worked and the Real Run didn't....I did manage to get it to work. I removed a hidden character and while it didn't change the Trial Run output, it did change the Real Run output.
All is good.
Posted: Wed Nov 02, 2005 6:34 am
by DataMystic Support
Hi there,
As documented in the help for the Trial Run Area, the Windows memo control automatically converts Unix end-of-line feed characters to Windows end-of-line characters. This can throw out filters that rely on one line type or another.
To make your filter less sensitive to this problem, start it off with a Convert end-of-lines filter with conversion from 'Auto detect' to "DOS (PC)'